Klemmsia Hold-down Clamp Adapter, Basic, Shaft 19 mm, Clamping Height 250 mm

The body of the hold-down clamp is the same as that of the Klemmsia clamps. It can be used for clamping down workpieces or converted into a standard clamp by means of the attached screw mechanism in the perforated stud system. It can also be used with C-slot profile rails thanks to the supplied groove screws (13 mm wide with 8 mm groove). The 40 mm high hornbeam block fitted to the lower end acts as a stopper and prevents the hold-down clamp from slipping. The included extension has the same height as the fitted hornbeam block, which allows even very thin workpieces to be firmly clamped to the workbench. The clamp features slip-resistant, surface-protecting cork pads and is therefore ideal for:

• Holding down workpieces
• Clamping round workpieces without damaging the profile
• Conversion into a standard clamp

Regulation of the clamping pressure via a cam lever. Movable clamp arm. Zinc-plated steel bar. Made of German hornbeam.